Specify to which value you want the registered hours to be rounded off. Employees registering their hours can fill in all values, such as '2:35 hours', but the value they enter will be rounded off in accordance with this setting.

The content of the picklist in this field depends on the setting in Isah that defines if you work with clock times (2:45 for 2 hours and 3 quarters) or decimal times (2.75 for 2 hours and 3 quarters).

Isah Time Registration works with variable working hours tables. In this field, specify the default variable working hours table Isah Time Registration needs to use if an employee doesn't have a variable working hours table in Isah.

Background

Isah knows two ways of registering hours:

• direct, which is what Isah Shop Floor Control does; employees clock the task they start and clock out when they leave or when a task is done, immediately resulting in hour lines in Isah
• afterwards, which is what Isah TR does: employees register their hours during or at the end of each week, but not necessarily immediately when they start a task.

The second method, employed by Isah TR, works best with variable hour tables. This is because specific start and end times are not always available if hours are registered afterwards, and that would be a problem for fixed hour tables. If an employee is scheduled to work with a fixed hour table but uses Isah TR for their hours, then Isah TR needs a variable hour table to register the hours correctly. For this purpose, it is best to register a general variable working hours table that will register (for example) the first 8 hours worked per day as 'standard working hours', and everything above that as 'extra hours', which could result in a higher hourly rate.

Every employee has to authorize their week report after registering their hours. If you want to prevent employees authorizing incomplete timesheets, activate the setting Check hours. Isah TR will compare the number of hours that the employee has registered (for direct and indirect activities, and absence) with the hours in their schedule. As long as the number of registered hours is smaller than the number of scheduled hours, the authorization icon will remain disabled, preventing employees from authorizing incomplete week reports.

If you leave this setting empty, it is possible for employees to authorize incomplete week reports.

If an employee has planned activities, these will be shown in their time sheet, making it easier for the emplyee to register hours. Isah also needs an hour code to be able to process these hours; set the default value for the hour code in this field, so you only need to register it once. The default hour code can be changed during the actual registering of activities.

If you leave this setting empty, employees can only apply for leave if they have sufficient leave hours remaining. Applications that would cause the remaining leave hours to become negative cannot be entered. Activate this field if your company allows the balance of leave hours for employees to become negative, for instance if you allow unpaid leave.

Specify the minimum amount of leave for a request. If, for example, a leave request has to be for at least two hours, set this value to '2'.

Specify the hour units allowed for leave requests. If, for example, leave can be requested only in 30-minute blocks, set the value to '0.50'. Employees will then be able to take leave only in multiples of half an hour.